Configure Static IP Address

Your Scanner is configured with DHCP by default. You can define a static IP address instead of DHCP. For more details on using IPv6-only mode, refer to Network Settings in IPv6-only Mode.

Perform the following steps to configure a static IP address:

  1. Access the Scanner Console.
  2. Press the Down arrow to select Set up network (LAN) from the main menu.
  3. Press the Right arrow to highlight Enable static IPv4 config.
  4. Press the Right arrow.
  5. Enter settings (use the Up/Down arrows to move through the settings).
  6. When Apply static IPv4 configuration on LAN? is selected, type Y is used to confirm.

    scanner_LAN_settings