Qualys PC Scan Status
Upon successful PC scan, Qualys PC Scanning connector generates the scan report for the respective Jenkins build with link name 'Qualys PC Scan Report for <target_asset_ip>.'
Perform the following steps to check the PC scan status:
- Go to Qualys PC Scan Results after the scan is complete.
- Click Summary tab. The report has four sections:
- Results Summary
- Scan Policies
- Overall Compliance
- Controls Causing Build Failure
- The header of the result shows the scan’s ID, name, and the link to view the scan result in the PC module. The sections give information on the total number of controls scanned for the selected policies and the graphical breakdown of the number of controls with statuses such as passed, failed, error, and exceptions. It also shows the total number of controls that met the failure conditions, which caused the build to fail.
- The 'Pass/Fail Criteria Results Summary section' shows in a matrix the count of failed, error, and exception controls found in the policy scan by their criticalities.
- In the Summary tab, when you click a policy name in the 'Scan Policies' section view its details in a separate policy tab. In the policy tab, you will see the scan result for the selected policy.
- Similarly, in the Summary tab when you click the count in the 'Controls using build failures' section, we show you details of these controls in the 'All Controls' tab.
- The 'All Controls' tab gives the details of the scanned controls, such as the control’s ID, title, criticality, policy name, status, and unexpected values. You can filter the controls by their criticality and status.
