Configure Static IP Address

You can choose to configure your appliance with a static IP address instead of DHCP.

To configure the static IP address, perform the following steps through Scanner Console:

1. Select Set up network (LAN).
2. Press the Right arrow to select Enable static IPv4 config.
3. Press the Right arrow again and enter the settings.

Enter Settings

Perform the following steps to enter into Settings:

1. Press the Up and Down arrows to select input fields.
2. Press the Right and Left arrows to scroll within fields.
3. When you are done, select the last item, for example, Apply static IPv4 configuration on LAN?, and type Y to confirm (or type N to cancel).

If you are using IPv6-only mode,  refer to the Network Settings in IPv6-only Mode for more details.

If you want to configure a static IP using Amazon EC2, refer to Scanning in AWS EC2 Environments.