Complete Network Configuration Using LCD Keypad

The following network configuration is applicable for QPS-01G-0100-A0.

Once the Appliance is turned on, the Welcome to Qualys! message appears in the LCD interface, followed by other informational messages during the boot process, which takes approximately two minutes.

We recommend reviewing and navigating the Appliance UI section before setting up the configuration.

Enable network configuration settings for the appliance, as appropriate.

• If the appliance is installed on a network with Static IP and without a Proxy server, you need to configure Static IP. Refer to the Configure Static IP Address section.
• If the appliance is installed on a network with DHCP and a Proxy server, you must configure Proxy. Refer to the Proxy Configuration section.
• If the appliance is installed on a network with a Static IP and a Proxy server, you need to configure both.
• Keep default configurations if the appliance is installed on a network with DHCP and without proxy.

Any errors must be resolved before continuing to Step 5. For help resolving errors, refer to Troubleshooting.

Next Step

Activate Appliance Using LCD Keypad